The Effect of Weigh in Motion Installation on Traffic Volume, Speed and Accident Rate of Goods Vehicles on The Pekanbaru – Dumai Toll Road
DOI:
https://doi.org/10.38035/sjtl.v4i2.959Keywords:
Weigh In Motion, ODOL, Traffic Volume, Speed, Accident Rate, Automated Enforcement, Toll RoadAbstract
This study aims to analyze the impact of implementing a Weigh In Motion (WIM) system on the traffic performance of freight vehicles on the Pekanbaru-Dumai Toll Road. The WIM was installed in response to the Circular Letter of the Minister of Transportation No. 116 of 2021 and functions as an automated enforcement technology to prevent Over Dimension Over Load (ODOL) vehicles from entering the toll road. The research method used was a one-group pretest-posttest experimental design with a descriptive-comparative quantitative approach. Secondary data was obtained from the toll road operator (PT Hutama Karya), covering three months before (December 2023 - February 2024) and three months after (March 2024 - May 2024) the WIM installation at four main toll gates. Three performance variables were analyzed: total traffic volume, average speed of freight vehicles, and the number of accidents involving freight vehicles. The analysis results show that after the WIM installation, there were changes with substantial practical significance: (1) total traffic volume decreased by 7.08% (from an average of 72,358 to 67,233 vehicles/month), indicating a filtering effect on ODOL vehicles; (2) the average speed of freight vehicles increased by 10.41% (from 29.88 km/h to 32.99 km/h), as an impact of improved traffic stream homogeneity; and (3) the number of freight vehicle accidents dropped sharply by 50% (from 2.67 to 1.33 incidents/month), with a large effect size (Cohen's d) of 1.155. The study concludes that WIM is effective not only as an enforcement tool but also as a traffic management instrument that creates a beneficial trade-off: a limited reduction in volume is exchanged for increased efficiency and, most importantly, a highly significant improvement in safety. This research recommends the expansion of WIM to other strategic toll road sections and further studies with longer observation periods and quasi-experimental designs.
References
Birgin, H. B., García-Macías, E., D’Alessandro, A., & Ubertini, F. (2023). Self-powered weigh-in-motion system combining vibration energy harvesting and self-sensing composite pavements. Construction and Building Materials, 369(September 2022), 130538. https://doi.org/10.1016/j.conbuildmat.2023.130538
Budiharjo, A., Andika, T., Fitriani, N., Rukman, R., & Turasno, B. (2022). Operational Data Analytics of Over Dimensional and Overloaded Truck in Indonesia. RSF Conference Series: Engineering and Technology, 2(2). https://doi.org/10.31098/cset.v2i2.562
Dontu, A. I., Barsanescu, P. D., Andrusca, L., & Danila, N. A. (2020). Weigh-in-motion sensors and traffic monitoring systems - Sate of the art and development trends. IOP Conference Series: Materials Science and Engineering, 997(1). https://doi.org/10.1088/1757-899X/997/1/012113
Famely, Masya. 2023. Disparitas Kecepatan Kendaraan Jadi Pemicu Kecelakaan di Jalan Tol. Jakarta.
Faruk, A. N. M., Liu, W., Lee, S. I., Naik, B., Chen, D. H., & Walubita, L. F. (2016). Traffic volume and load data measurement using a portable weigh in motion system: A case study. International Journal of Pavement Research and Technology, 9(3). https://doi.org/10.1016/j.ijprt.2016.05.004
Gusthia, Indraloka. 2023. Mengenal Lebih Jauh Dengan Truk. Bogor.
Hobbs, F.D. 1995. Perencanaan dan Teknik Lalu Lintas. Yogyakarta
Irawan, M.Z. 2014. Volume Lalu Lintas dan Karakteristik Kecepatan. Yogyakarta.
Karim, M. R., Ibrahim, N. I., Saifizul, A. A., & Yamanaka, H. (2014). Effectiveness of vehicle weight enforcement in a developing country using weigh-in-motion sorting system considering vehicle by-pass and enforcement capability. IATSS Research, 37(2), 124–129. https://doi.org/10.1016/j.iatssr.2013.06.004
Kementerian PUPR. 2020. Diresmikan Presiden Secara Virtual, Tol Pekanbaru - Dumai Sepanjang 131 Km Tingkatkan Pertumbuhan Ekonomi Daerah di Provinsi Riau. Jakarta.
Kerja sama Fakultas Hukum Universitas Gadjah Mada dengan Asosiasi Pengusaha Indonesia (Apindo). 2020. Kajian Zero ODOL (Over Dimension Over Loading), Membangun Kebijakan Transportasi Darat yang Efektif di Indonesia. Yogyakarta.
Nugraha, Widi. 2014. Weigh In Motion Pengukur Beban Kendaraan Bergerak. Bandung.
Oktarinda, E., Prihutomo, N. B., & Maulani, E. O. (2022). Analisis Pengaruh Kendaraan Odol Terhadap Tingkat Kecelakaan Di Jalan Tol. Construction and Material Journal, 4(1), 49–57. https://doi.org/10.32722/cmj.v4i1.4151
Republik Indonesia. 1993. Peraturan Pemerintah Nomor 43 Tahun 1993 tentang Prasarana dan Lalu Lintas Jalan. Jakarta.
Republik Indonesia. 2009. Undang Undang Nomor 22 Tahun 2009 tentang Lalu Lintas dan Angkutan Jalan. Jakarta.
Republik Indonesia. 2014. Peraturan Pemerintah Nomor 74 Tahun 2014 tentang Angkutan Jalan. Jakarta.
Republik Indonesia. 2015. Peraturan Menteri Perhubungan Nomor 96 Tahun 2015 tentang Pedoman Pelaksanaan Kegiatan Manajemen dan Rekayasa Lalu Lintas. Jakarta.
Republik Indonesia. 2019. Peraturan Menteri Perhubungan Nomor 60 Tahun 2019 tentang Penyelenggaraan Angkutan Barang dengan Kendaraan Bermotor di Jalan. Jakarta.
Republik Indonesia. 2019. Surat Edaran Menteri Perhubungan Nomor 21 Tahun 2019 tentang Pengawasan terhadap Mobil Barang atas Pelanggaran Muatan Lebih (Over Loading) dan/atau Pelanggaran Ukuran Lebih (Over Dimension). Jakarta.
Republik Indonesia. 2021. Surat Edaran Menteri Perhubungan Nomor 116 Tahun 2021 tentang Pengawasan dan Penindakan terhadap Kendaraan Angkutan Barang atas Pelanggaran Ukuran Lebih (Over Dimension) dan/atau Pelanggaran Muatan Lebih (Over Loading) di Jalan Tol. Jakarta.
Saputra, A. D. (2018). Studi Tingkat Kecelakaan Lalu Lintas Jalan di Indonesia Berdasarkan Data KNKT (Komite Nasional Keselamatan Transportasi) dari Tahun 2007-2016. Warta Penelitian Perhubungan, 29(2), 179. https://doi.org/10.25104/warlit.v29i2.557
Septiana, T., & Zaini, Z. (2018). Perancangan dan Implementasi Sistem Monitoring Beban dan Kecepatan Kendaraan Menggunakan Teknologi Weigh in Motion. Jurnal Nasional Teknik Elektro, 7(1), 60. https://doi.org/10.25077/jnte.v7n1.512.2018
Setijowarno, Djoko. 2022. Niat Bersama Menertibkan Truk ODOL. Semarang.
Simatupang, T. M. (2020). Over Dimension dan Over Load ( ODOL ) Kilasan. Seminar Nasional “Transportasi Truk ODOL (Over Dimension and Over Load) Kerjasama Asosiasi Pengusaha Truk Indonesia (APTRINDO) Dengan Centre for Sustainable Development Studies (CSDS) Fakultas Interdisiplin UKSW Gedung Pascasarjana UKSW Salatiga Senin 13.
Sukirman, Silvia. 1999. Dasar - Dasar Geometrik Jalan. Bandung.
Syarif, I. A., & Muis Prasetia, A. (2019). Aplikasi Weigh in Motion Menggunakan Metode Estimasi Untuk Mengukur Beban dan Kecepatan Kendaraan Bergerak. Borneo Engineering : Jurnal Teknik Sipil, 3(1), 14. https://doi.org/10.35334/be.v3i1.701
Wibisono, G. I., Ramadan, F. E., & Fajar, A. H. (2019). Analisis Lalu Lintas Harian Rata - Rata (LHR) dalam Menghindari Kecelakaan. Jurnal Manajemen Bisnis Transportasi Dan Logistik (JMBTL), 5(3), 359–366. http://library.itl.ac.id/jurnal
Wulandari, Nuraini. 2022. Menuju Indonesia Bebas ODOL. Jakarta.
Yostisa, Rezky. 2021. Kajian Pengendalian Over Dimension Over Loading. Jakarta.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 Arief Yeri Krisnanto, Aang Gunawan, Primadi Candra Susanto

This work is licensed under a Creative Commons Attribution 4.0 International License.
Copyright :
Authors who publish their manuscripts in this journal agree to the following conditions:
- Copyright in each article belongs to the author.
- The author acknowledges that the Siber Journal of Transportation and Logistics (SJTL) has the right to be the first to publish under a Creative Commons Attribution 4.0 International license (Attribution 4.0 International CC BY 4.0).
- Authors can submit articles separately, arrange the non-exclusive distribution of manuscripts that have been published in this journal to other versions (for example, sent to the author's institutional repository, publication in a book, etc.), by acknowledging that the manuscript has been published for the first time at SJTL.
























